V1 AIR INDUCTION SYSTEM (ALFA ROMEO GIULIA/STELVIO 2.9L QV)

INTAKE SYSTEM
$796.00
$796.00

EUROCOMPULSION® is pleased to present the V1 Air Induction System (Intake) for the ALFA ROMEO GIULIA/STELVIO QV 2.9L Twin Turbo. The V1 Induction Kit replaces the factory plastic intake pipes in favor of larger diameter silicone piping, utilizing our premium 4ply Silicone with KEVTEK reinforcement and construction. Our high quality silicone offers more efficient flow and retains cooler air temperatures going into the turbo. This kit is completely PLUG & PLAY.

Our V1 is constructed with a rigid, wire-reinforced skeleton and 5 total layers of heavy duty silicone built to withstand thermal absorption of engine bay heat and pressure. The V1 contains larger diameter piping throughout, with multiple transitions up to the inlet to maximize air flow. This stepped design, which is different than standard metal or carbon fiber piping, provides laminar flow while reducing air turbulence. The smoothed interior walls and extremely low thermal conductivity of our silicone will provide cooler and denser air to the turbo inlet increasing engine efficiency and power output. Decreased restrictions allow for higher flow volume and significantly reduced pressure loss. The V1 design also allows for slightly louder turbo noises and audible whooshes. 

PERFORMANCE:

  • Through lower temperatures and increased flow, this intake provides 14WHP & 17WTQ when combined with our EUROCOMPULSION Hi Flow Drop in Filter for the Giulia/Stelvio QV. Up to 25whp when combined with a EURO+DRIVE ECU tune.
  • The V1 Intake system lowered intake air temperatures by 16% over the stock intake at wide open throttle.

The EC drop-in air filter utilizes an advanced filter media that improves flow by an average of 10-12% over similar style filters. This filter media filters media down to 5 microns. EUROCOMPULSION filters are created in-house, and feature a non-woven dry cotton pleat, designed as a sheet to offer sustainable filter longevity for superior filtration, and increased flow/performance. Can be run dry or oiled.

Included with this kit are (2) V1 Intake pieces, (2) machined EVAP venturi pieces with associated silicone hoses, and clamps. Available in Red or Black. Also available with our EUROCOMPULSION Hi Flow Drop in Filter, the BMC Filter, or no filter.


FEATURES:

  • Increased Power Output (14whp/17wtq with drop in filter)
  • Reduced Air Intake Temperatures (16% lower than the stock system)
  • Increased Air Density at the turbo Inlet
  • Reduced Pressure Losses in the intake tract
  • Increased diameter transitions for more air volume
  • Stepped transitional design for increased laminar flow and decreased turbulence
  • Maintains all factory emissions and vacuum routing
  • Easy Installation, no alteration to vehicle required
  • Will NOT trigger Check Engine Lights
  • New Machined EVAP Venturi
  • Increased Aesthetics
  • Uses optional High Flow Air filter, advanced filter media, and filtration
  • Easily reversible
  • 100% Plug & Play
  • Includes all necessary Clamps, Fittings, and Hoses
  • World Wide Fitment for the Giulia/Stelvio QV 2.9L Petrol (Gasoline Engines)

 

APPLICATION:

  • Alfa Romeo Giulia QV 2.9L Twin Turbo (2017-present)
  • Alfa Romeo Stelvio QV 2.9L Twin Turbo (2017-present)

TECHNICAL INFO/DYNO CHARTS: HERE ( or See Tech Info Tab)

INSTALLATION INSTRUCTIONS: HERE (or See Installation Tab)

     MEDIA:


    Read More
    Read Less

    - INTAKE AIR TEMPERATURE TESTING 

    The EC V1 Intake and Stock Intake pieces were tested on single gear pulls (road testing) starting from 2200rpm up to redline. These tests were performed back to back on the same day, and data is compiled from 10 run averages for each intake piece. 

    • - Ambient Temp = 88F - 90F Average 
    • - EC V1 Intake = 111F - 113F Average (WOT) 
    • - Stock Intake = 128F - 132F Average (WOT) 

    *Testing Note: Temperatures tend to stabilize anywhere from 5-10F above WOT temperature prior to going full throttle (during cruise and part throttle driving).

     

     

     

    - DYNO TESTING

    Dyno testing was performed on a 2018 Alfa Romeo Giulia QV (US Spec) w/91 octane fuel. Modifications were EC V1 Intake and the EC Performance Hi-Flow Filter drop in. Runs were done back to back with stock intake switched out on the dyno. 

     

     

    - INSTALLATION INSTRUCTIONS (coming soon)

    Eurocompulsion cannot guarantee the success or stated power gains while using modifications not tested in house or recommended. When testing results, always follow proper dyno procedures, use appropriate fuel, and compare to vehicle specific stock deltas. Eurocompulsion is not responsible for damage caused by or incurred by other modifications or user error/installation error by user or third party. Off-Road & Race Use Only. “Not legal for sale for, or use on, pollution-controlled vehicles.” “Legal only for racing vehicles which may never be used upon a highway. Not applicable or intended for street or highway use.”

    Customer Reviews

    Customer Reviews

    Based on 5 reviews
    100%
    (5)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    F
    Felix Matos
    Looks and feels great!

    Great fit and finish. Easy to install and noticeable power increase with the “Butt Dyno”. Really happy with how it came out.

    E
    Edward McConville
    Excellent customer service

    Have only used Eurocompulsion once but the customer service I received from Jordan was amazing. There knowledge was also excellent. 👌

    S
    Simon English
    Outstanding as always!!

    With every performance upgrade now installed plus the tune, the induction system from EC was worth the wait.
    Definitely makes a difference because my timing for shifting into 2nd is off😂 and I'm late over and over. So now have to make a mental adjustment when to shift. There were other induction systems out there and I held off because non of them adequately dealt with heat, all were focused on pushing more air through and nothing more.
    EC always do their due diligence, they do proper research and development, they don't just rush products to market. I couldn't be happier with EC products, other products they sell and the customer service they provide!! I have purchased products from EC for 4yrs now.

    Items I have-
    EC ECU Tune
    Redstar Decat downpipes(ceramic coated)
    EC Heat exchanger
    Forge recirculating valve
    BMC filter
    EC induction system
    5mm spacers all round

    B
    Babak Kiaei
    Nice Intake

    Very simple to install straight out the box. Nice color combo (Black and red). Keeps my temperature levels down and keeps me going hard 😃

    A
    A.S.
    You need this!!

    Being one of the first two vehicles to have used this product for a few months has been fun with this upgrade. Half the price of the competition and absolutely zero issues. The power is there waiting to be unleashed. The entire EC crew knocked it out of the park with this product. Acceleration pickup is so much smoother and you can absolutely feel it!

    We use cookies to improve your experience on our website. Read about how we use cookies in our Privacy Policy. By browsing this website, you agree to our use of cookies. privacy policy
    accept

    Your cart

    ×