The EURO+DRIVE® CLONE Tuning System allows you to physically swap calibrations on your ABARTH/500T. Using genuine OEM Fiat/Abarth based software, protocols and calibrations, we have increased drive-ability, power and throttle response. We are proud to have the ability to offer you the most comprehensive tuning option for your Abarth/500T. Each purchase includes a Genuine Abarth/500T Engine Control Unit (If Clone is selected) loaded with our calibration. Designed and developed for the North American Abarth and Fiat 500T.
The EURO+DRIVE® DIRECT Tuning System is an economical solution in loading calibrations on your Abarth/500T. Using genuine OEM Fiat/Abarth based software, protocols and calibrations, we have increased drive-ability, power and throttle response. We are proud to have the ability to offer you the most comprehensive tuning option for your Abarth/500T. Each purchase includes our calibration loaded onto YOUR Engine control Module. Designed and developed in the USA.
FEATURES:
- Designed on the North American Abarth/500T
- Use of Genuine OEM Software,Maps and Protocols
- Simple 10-15 min INSTALLATION/REMOVAL
- Preserves factory ECU/WARRANTY (if CLONE is selected)
- Calibrations will Optimize power, drive-ability, and efficiency
- Unparalleled consistent, linear, & smooth power delivery
- Calibrations will retain OEM tuning logic and ALL safety parameters
- All factory hardware works properly/efficiently
- Full control over all engine parameters by utilizing true factory Calibrations
- Specially requested Calibrations available (additional fees may apply)
- 91oct minimum fuel requirement
- Strong, Reliable power where and when you need it
EURO+DRIVE® CALIBRATIONS:
- ~154 WHP 695 F.T.
- ~178 WHP PHASE 0
- ~189 WHP PHASE 1
- ~209 WHP PHASE 2
WE CANNOT GUARANTEE THE ADVERTISED GAINS IF YOU HAVE MODS WE HAVE NOT TESTED IN HOUSE.
SUPPORTED YEARS:
-
2012 - AVAILABLE
- 2013 - AVAILABLE
- 2014 - AVAILABLE
- 2015 - AVAILABLE
- 2016 - AVAILABLE
- 2017 - AVAILABLE
- 2018 - AVAILABLE
- 2019 - AVAILABLE
Dyno Charts/Info: HERE
Tune Requirements: HERE
TECHNICAL INFORMATION: HERE
NOTES:
Once purchased please send your factory ECU to:
- EUROCOMPULSION-OK
- 10763 Sahoma Lake Road
- Sapulpa, OK 74066 
This applies to both Euro+Drive Clone and Direct tuning Options, you must ship your original factory ECU. Please ensure your factory ECU is packaged properly to prevent damage. For clone purchasers you will receive your factory ECU and your Clone unit upon return. Turn-around time is approx. 24hrs-72hrs. (The Epoxy requires 16hrs-24hrs to fully cure.)