- Disconnect your Vehicles battery at the negative terminal.
- Unplug your accelerator pedal. The plug is near the top of the pedal itself.
- Take that plug, and plug it into connector number 1 shown in the picture below.
- Take connector number 2 and plug it into the accelerator pedal.
- Plug connector number 4 into receptacle 5 in the control box.
- Unplug the control head to make it easier to route it's wire back to the control box.
- Attach the control head to the dash via double sided tape.
- Route the wire back to and plug it into the control box.
- Tuck the control box an wiring away so they will not interfere with operation of the vehicle.
- Re connect the vehicle battery.
- Now do the initial set up of the device:
- Ignition ON but with engine OFF
- Hold Mode → release at “L”
- 0% pedal → press Mode
-
Floor it → set 100% → press Mode
Congratulations, you have successfully installed your EC Pedal Booster!
How to use the EC Pedal Booster:
Mode Selection:
Tap the Mode button to cycle through:
• Power
• Normal
• Eco
Adjust Responsiveness
Use the Up or Down arrows to increase or decrease response sensitivity
• Power Mode (1–9): Higher levels = quicker throttle response
• Eco Mode (1–7): Higher levels = more pedal travel for smoother, fuel-efficient driving
• Normal Mode: OEM pedal response
Advanced Features:
Anti-Theft Mode
Hold the Mode button while in Eco Mode until the screen goes blank. Your accelerator pedal will no longer respond.
To turn it off:
Hold the Mode button with the vehicle in Park/Neutral until the display returns.
Drag Strip Mode
Hold the Mode button in Power Mode until a flashing 0 appears.
Your throttle becomes a hair trigger—instant full throttle.
⚠️ Do NOT reverse while Drag Strip mode is active!
To disable: Hold the Mode button until the normal display returns.
❄️ Anti-Slip Mode
Press and hold the Up + Down arrows together until the screen number disappears and the anti-slip symbol appears.
To turn it off:
Press any button.